INTRODUCTION
Sysmex SF-3000 Operator's Manual -- Revised September 1995 1-17
10. PASSWORD
Some programs in Q.C., Settings and Calibration require a password entry to prevent
unauthorized changes of the important settings and values. When such a program is
selected, the Password Input Screen appears with the message "Input Password". Enter
the registered password and press the [Enter] key. If the entered password is correct, the
program will be executed.
Input Password
Password
***
Sysmex
DP:1234567890123
XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
7 8
4
9
65
1 2 3
0 Ð Enter
C
Cancel
.
Figure 1-7: Password Entry Screen
The password is important for the management of the SF-3000, so be sure to memorize it
and/or have aids to help you remember it. Should you forget it, consult your Sysmex
service representative.
The password can consist of up to 12 digits. If you set the password to "0", no
password check will be performed, and the programs will be executed without the need
of password input.
For the procedures for setting and changing the password, refer to Chapter 11, "System
Setup".
To Next Page
Loading...
