SYSMEX SF-3000 - Page 305

CALIBRATION, Overview of HGB/HCT Auto Cal. program
Sysmex SF-3000 Operator's Manual -- Revised September 1995 7-5
(4) Press [Return] key. The confirmation message "Exit Auto Cal. OK?" will appear.
Exit Auto Cal. OK?
O K
Cancel
Figure 7-4: Confirmation Message Window
Pressing [OK] erases all data and ends the HGB/HCT Auto program.
Pressing [Cancel] retains the calibration data generated, permitting HGB/HCT Auto
program to continue.