TROUBLESHOOTING
8-26 Sysmex SF-3000 Operator's Manual -- Revised September 1995
Rack Feed In Function Error
Phenomena A sample rack cannot be forwarded to the measurement line properly.
(The rack feed in function sensor does not turn ON within preset time limit.)
The sample being processed will be completed. After that, sampler operation
cannot be continued until the error is resolved, however, manual analysis is
possible.
The "Reset Rack" error message also appears.
Probable Cause 1) Blood, etc. has interfered with the rack feed in function sensor.
2) A foreign object is in the right rack pool blocking the sensor or rack.
3) Rack jammed or was picked up.
4) The rack feed in function sensor is defective.
Corrective Action 1) Remove dirt.
2) Remove all foreign objects from the right rack pool.
3) Reset the rack in the right rack pool and press [Sampler], then [Start] key
to resume the analysis.
4) If the error persists, contact your Sysmex service representative.
Rack Feed In Home Pos. Error
Phenomena A sample rack cannot be forwarded to the measurement line properly.
(The rack feed in home position sensor does not turn ON within preset time
limit.)
The sample being processed will be completed. After that, sampler operation
cannot be continued until the error is resolved, however, manual analysis is
possible.
The "Reset Rack" error message also appears.
Probable Cause 1) Blood, etc. has interfered with the rack feed in function sensor.
2) The rack feed in home position sensor is defective.
Corrective Action 1) Remove dirt.
2) Check the rack feed in operation using test program. (Refer to
Section
3.6: Test Sampler
in this chapter.)
3) If the error persists after the test program is completed, turn the Main Unit
power OFF, then ON again.
4) If the error still persists, contact your Sysmex service representative.
To Next Page
Loading...
