TROUBLESHOOTING
Sysmex SF-3000 Operator's Manual -- Revised September 1995 8-37
RBC Fast To Start
RBC Count Too Short
Phenomena The ball float in the manometer descends to the Stop Level via Start Level
faster than the preset time limit.
An analysis error may occur, and the "Check Stored Data" message also
appears.
The sample being processed is completed, and the system returns to Ready.
If the system is set to be stopped by this error, the system will be STAT ready
for the sample analysis in manual or capillary mode.
If the system is set to continue analysis when this error occurs, the system
will process the next sample.
Probable Cause 1) Air bubbles exist inside the manometer unit.
2) Insufficient sample has entered the transducer chamber.
3) The vacuum is high.
Corrective Action 1) Execute clog removal sequence. Refer to
Chapter 5, Section 7.2:
Execute RBC Aperture Clog Removal Sequence
.
2) Check that sample is reaching the RBC transducer chamber.
3) Check and adjust 250 mmHg vacuum if required. Refer to
Chapter 9,
Section 4: Main Unit Adjustment
.
4) If the error persists, contact your Sysmex service representative.
Close RBC Detector Cover
Close WBC Detector Cover
Phenomena RBC and/or WBC detector cover is open.
An analysis error may occur, and the "Check Stored Data" message also
appears. Analysis cannot be continued until the error is resolved.
Probable Cause 1) The cover is open.
2) The detector cover sensor is defective.
Corrective Action 1) Close the detector cover(s).
2) If the error persists, contact your Sysmex service representative.
To Next Page
Loading...
Need help?
General
