SYSMEX SF-3000 - Page 474

SYSTEM SETUP, Auto Management Programs
Sysmex SF-3000 Operator's Manual -- Revised September 1995 11-5
(3) Press a desired keypad to execute the program.
When [Output Mode], [Auto Erase] or [Auto Valid.] key is pressed, the Input
Password window will appear. Input the registered password and press
[ENTER].
Input Password
Password
***
7 8
4
9
65
1 2 3
0 – ENTER
C
CANCEL
.
Output
Cond.
Output
Mode
Auto
Erase
Auto
Valid.
Return
DP:1234567890123
Sysmex
XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
• Settings •
Figure 11-3: Password Input Window
(4) Proceed each program by referring to the following sections.
(5) When [Quit] key is pressed to exit the setting program, the confirmation message
window will appear. Press the appropriate key [Continue], [Set] or [Cancel].
< AUTO OUTPUT CONDITION >
Quit
DP:1234567890123
Sysmex
XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
Output
Cond.
Return
Continue Set Cancel
Execute settings.
D P
G P
H C
F I F O L A S T
F I F O
F I F O
S T O P
S T O P
S T O P
Figure 11-4: Example of End of Setting Window
Continue : To return to the previous screen so that setting can be continued.
Set : To save the new settings. Program ends.
Cancel : To cancel the new settings. Program ends.