SYSTEM SETUP, DP Setting
11-40 Sysmex SF-3000 Operator's Manual -- Revised September 1995
Printed
MCV
Print Type
WBC
Print Type
Not Printed
< DP Settings >
Diff Data
on Positive
***.* ** *
***.****.**
More Quit
Return
DP:1234567890123
Sysmex
XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
HC
Setting
GP
Setting
DP
Setting
√
Figure 11-32: DP Setting Screen - 2
MCV Print Type : Specify whether numerals after the decimal point are to
be printed for MCV data.
(The factory setting is "***.*".)
NOTE: If numerals after the decimal place are not printed for MCV, the
number before the decimal place is rounded up or down to the
nearest unit.
WBC Print Type : Select the WBC print format. The options are
"***.**" (5 digits) and "***.*" (4 digits).
(The factory setting is "***.**".)
DIFF Data on Positive : Use this program to specify whether the WBC 5 part
differential results for a Positive Sample are to be
printed or not. (The factory setting is "Printed".)
(4) Press [Quit] key to exit the program. The confirmation message will appear. Press
the appropriate key [Continue], [Set] or [Cancel].
Continue : To return to DP setting screen so that setting can be continued.
Set : To save the new settings. Program ends.
Quit : To cancel the new settings. Program ends.
To Next Page
Loading...
