SYSMEX SF-3000 - Page 604

x Sysmex SF-3000 Operator's Manual -- Revised September 1995
[T]
Target/Limit, QC
Auto Setting 6-21
Display 6-13
Lot Information 6-28
Manual Change 6-25
Read FD 6-15
Temperature Errors, Troubleshooting 8-11
Temperature, Environmental 1-20
Temperature/Pressure Check 2-4
Test
Bar Code Reader 8-74
Data Printer (DP) 8-80
Floppy Disk (FD) 8-76
Graphic Printer (GP) 8-81
Host Computer (HC) 8-82
Laser Unit 8-70
LCD 8-78
Memory 8-75
Motor 8-63
Output 8-80
PDA PCB 8-69
Piercer Mechanism 8-73
Sampler 8-71
SRV 8-62
Touch Panel 8-79
Test Programs 8-59
Text Format, Host C-8
Thermostat 10-34
Throughput 1-21
Timer Mode 2-51
Setting 11-48
Top Interior, Nomenclature
Pneumatic Unit 10-34
Sampler Unit 10-36
Top Same Day, Search, Stored Data 4-39
Top, Sampler Unit 10-35
Top, Search Stored Data 4-38
Touch Panel, Test 8-79
Transmission Protocol, Serial Interface C-6
Transmission Procedure, Serial Interface C-5
Trap Chamber, PU, Remove Fluid 5-6
Trap Chamber, Vacuum 10-32
Tray
Clean 5-7
Install B-11
Tube Clamp Error, Troubleshooting 8-33
Tube Connection B-22
Tube Invert Position Error,
Troubleshooting 8-32
Tube Sensor Error, Troubleshooting 8-33
Turning On the Power 2-4
Types of QC Method 6-2
[U]
Units, Set 11-45
Unpacking Check List B-2
Update Calibration Value 7-12
Update Reagent Log 5-47
[V]
Vacuum Errors, Troubleshooting 8-9
Vacuum Gauge 9-1, 10-32
Vacuum Orifice 10-24
Vacuum Trap Chamber 10-32
Validation, Data 4-24
Validation, Auto, Set 11-11
Variable Target Function 6-51
Calculation 6-51
Erroneous Data 6-52
Vacuum Line, Connection B-22
Version Check 8-83
Visual Inspection for Laser Safety 5-26
[W]
Waste Chamber 1 Not Draining,
Troubleshooting 8-16
Waste Chamber 2 Not Draining,
Troubleshooting 8-16
Waste Chamber 3 Not Draining,
Troubleshooting 8-16
Waste Chamber
Clean Sequence 5-16
Location 10-27
Waste Container
Install B-27
Replace 5-45
Waste Fluid, Check 2-3
Waste Outlet Nipple 10-21
WB Asp Motor Controller Error,
Troubleshooting 8-44
WB Asp Motor Function Error,
Troubleshooting 8-20
WB Asp Motor, Test 8-63
WBC Analysis, Sample Flow 10-4
WBC Classification 10-8
WBC Detector, Clean Sequence 5-9
WBC Detector Temp High,
Troubleshooting 8-13
WBC Detector Temp Low,
Troubleshooting 8-13
WBC Detector Thermal Sensor Discon.,
Troubleshooting 8-14
WBC Flow Cell 10-2
Air Bubbles Removal Sequence 5-41