SAMPLE PROCESSING, Auto Mode Procedures
Sysmex SF-3000 Operator's Manual -- Revised September 1995 2-31
CAUTION: • If the bar code is affixed in the area of blood
volume sensor, the volume of sample cannot
be accurately monitored.
• To prevent instrument damage and ensure
that the tube can be properly mixed and
sampled, make sure that the bar code label
does not extend beyond the bottom of the
sample tube.
2 . Input Sample ID Number (if bar code not used)
If an ID bar code reader is not used, the sample ID number must be input manually
before analysis is performed.
(1) Make sure that the instrument is in Ready status. The READY LED should be lit
and the message "Ready" should appear on the LCD.
(2) Press the [Sampler] keypad in the upper right corner of the LCD. The Sampler
Start Check window will appear.
Sysmex
DP:1234567890123 XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
Sampler Start check
Rack
Tube
Sample
No.
Cancel Start
1234
1
123456
Figure 2-23: Sampler Start Check Window
To Next Page
Loading...
