SYSMEX SF-3000 - Page 95

WORK LIST, Data Entry
Sysmex SF-3000 Operator's Manual -- Revised July 1996 3-5
[Repeat] key : When this key is pressed, "Repeat" is displayed above the numeric
keys.
Enter the number of samples to enter the order information and press
[Enter].
The Rack-Tube and Sample ID No. which are incremented by one to
those of the previous sample will be assigned. The analysis order
information appears the same as the previous sample. See the
example below.
Example)
When the cursor is on a sample with order information;
Rack-Tube: "0001-01", Sample No.: "123-456", Order " "
Pressing [Repeat], [3], then [ENTER] keypads will assign the
following three samples as below:
Rack-Tube: "0001-02", Sample No.: "123-457", Order " "
Rack-Tube: "0001-03", Sample No.: "123-458", Order " "
Rack-Tube: "0001-04", Sample No.: "123-459", Order " "
NOTE: Since the order information can be input on up to 50
samples, a number between 1 and 49 can be accepted
after pressing [Repeat] key.
NOTE: When the cursor is placed on the bottom of the list, [ ↓ ]
key functions as repeat key when pressed, which will
assign the Rack-Tube Position No. and the Sample No.
incremented by one to those of the previous sample.
NOTE: A number will be carried beyond a hyphen. For
example, the Rack-Tube No. following 0001-10 will be
0002-01, 0001-01 will follow 9999-10.
[0] - [9], [–] : Inputs number or a hyphen.
[QC] : Press this key to set the QC samples by registering the QC File No.
in which the L-J QC analysis results are stored as control data. For
example, press [QC] and [1] keys to specify the QC File No. 01.
[ENTER] : Sets the input values.
[C] : Used as a backspace key to delete one character.
Sysmex SF-3000 Operator's Manual -- Revised September 1995