05-40
CORROSION PREVENTION
The surfaces that need particular care are the following:
Inspection compartments, wing attach-
ments, stabilator attachments
MLG compartment, NLG compartment,
springs, gear attachment, metric bolts, nuts
and pins
LH and RH wing attachment plates
Vertical and horizontal stabilizers an hing-
es
All metric bearings and terminals
Not on exhaust components
Corrosion prevention Table.
Note: use the ACF-50 in closed hangar and make sure that the product is always under the
temperature limits indicated on the technical data sheets.
Note: remove all traces of salt water and salt water residue by thoroughly washing the air-
craft with fresh water after flights near sea and on airfields close to salt water area (sea or
salt lakes).
To Next Page
Loading...
