Page 200 2
nd
Edition – Rev 0
12-20
OIL SYSTEM – SERVICING PRACTICES
12-20 OIL SYSTEM - SERVICING PRACTICE
General
Following paragraphs shows the procedures for oil level checking, filling and change.
APPROVED OIL SPECIFICATION: use only oil with API classification "SG" or higher. At the
selection of suitable lubricant, refer to the additional information provided by Rotax Operators
Manual P/N 899371 (Operating media Section) - last issue
Make certain that fluids and fluid containers are protected from
contamination of any kind.. If there is any doubt regarding the
cleanliness of the fluid, do not use it. Containers for fluid must
never be left open to air longer than necessary.
Allow the engine to cool down to the ambient temperature before
start of any work.
ù
To Next Page
Loading...
