Tecnam P2002 JF - Strobe Lights Mode Switch; Vfr External Additional Configuration; VFR Night Landing Light

Page 3 2
nd
Edition – Rev 0
33-20
EXTERNAL LIGHTS – DESCRIPTION AND OPERATION
Figure 8. – Strobe light
VFR EXTERNAL ADDITIONAL CONFIGURATION
Strobe lights mode switch
Strobe lights (located on the wings and on the vertical tail) are activated by means of a switch
located on the instruments panel, RH lower side.
The strobe lights mode switch, instead, allows for selecting two operational modes;
NORM: all strobe lights are ON;
EMER: only the strobe light on the vertical fin ON.
The switch allows for reducing electrical loads in event of electrical system failures.
Figure 9. - Switches
Landing lights
Landing lights is located under the engine nacelle, instead of the left wing leading edge, in
order to prevent pilot blinding during night operations.
Figure 10. – VFR night landing light