Page 203 2
nd
Edition – Rev 0
12-20
OIL SYSTEM – SERVICING PRACTICES
Oil Change Procedure
At the selection of suitable lubricants refer to the additional information
provided by Rotax Operators Manual P/N 899371 - last issue
1. Remove upper and lower engine cowling
2. Run engine to warm oil before beginning oil change procedure
3. Engage parking brake, master switch OFF, disconnect battery
4. Crank engine by hand to transfer the oil from the crankcase, then apply “oil
level checking” procedure to record oil consumption
5. Remove safety wire and oil drain plug (refer to Figures 4. And 5.) and apply
“Oil change” procedure addressed on Rotax Engine Maintenance Manual P/N
899735 disposing used oil as per environmental regulations
6. Install oil drain plug with safety wire
7. Re-install upper and lower engine cowling
Remove and replace engine oil filter at each oil change. Refer to Rotax
Engine Maintenance Manual P/N 899735 – last issue, for detailed
instructions.
In event of heavy oil contamination, it is necessary to perform
the oil tank cleaning operation. Refer to Par 12.22
Figure 4. – Oil tank drain valve
To Next Page
Loading...
