Tecnam P2002 JF - Software Upload

2
nd
Edition - Rev 0
SUPPLEMENT SG-3
CHAPTER 31 - INDICATIONG SYSTEM
Page 205
SOFTWARE UPLOAD
The following instructions apply for the SW installation as performed on the
assembly line. The G500 is not airworthy unless software and configuration
procedures are accomplished successfully as described in these procedures. It is
extremely important that each LRU software load be completed successfully.
Required Materials and Equipment
Make sure that all of the required materials and equipment are on hand before you
begin the upgrade procedure.
 A ground power unit capable of supplying 14 VDC power to the aircraft systems and
avionics
 G500 P2002 Software Loader Card applicable P/N
 G500 P2002 Installer Unlock Card P/N 010-00769-60
 G500 P2002 Loader Card Software Configuration –Drawing N° 22-9-007-1 sheet 2
“Garmin G500 Software”
System SW Upload procedure
The system software upload procedure for G500 system must be performed load-
ing the software for each installed unit.
Before starting the SW upload procedure
Before loading software to the G500 system perform the following operation:
Step
no.
User settings clearing
Additional info
&References
1.
Master OFF
2.
GDU breaker: pull
Optionally, the technician
may remove power from
the stand-by instruments by
pulling the circuit breakers
3.
GRS breaker: pull
4.
GDC breaker: pull
5.
Insert the correct Installer Unlock Card (010-
00769-60) into the GDU620 bottom card slot