Tecnam P2002 JF - Aileron Installation

Page 209 2
nd
Edition - Rev 0
57-10
WINGS – MAINTENANCE PRACTICE
6. AILERON INSTALLATION
Procedure
Step no.
Task description
Additional info &
References
1
Position the aileron in the wing and in-
stall bolts, washers and nuts at the
hinges
2
Connect mass balance
3
Connect aileron control rod to the ailer-
on with bolt, washer and nut.
4
Check aileron control cables tension
See chapter 20
5
Align aileron trailing edge with wing
tip trailing edge with usable means.
This position is 0° posi-
tion for ailerons
6
Check ailerons travel limits: UP 20°
and Down 15° (± 2°)