Tecnam P2002 JF - Pitot-Static System - Leak Test

Page 202 2
nd
Edition – Rev 0
34-10
PITOT-STATIC SYSTEM – MAINTENANCE PRACTICES
2. PITOT-STATIC SYSTEM – LEAK TEST
Always perform Pitot and static system leak test after any maintenance operation
on the Pitot-static system.
In succession, important precautions for leak tests are listed: follow them in
order to avoid Air Data Instruments damages.
 Pressure applied during tests and its rate of change must not exceed
limits imposed by instruments’ manufacturers.
 After testing, do not forget to restore the whole system to its operating
configuration.
Tools
Item
Quantity
Part Number / Notes
Pitot-static tester
1
ADTS500 by DRUCK or equivalent
equipemnt
Pitot tube adaptor
1
Commercial
Static port adaptor
2
Commercial
T-joint
1
Commercial