Tecnam P2002 JF - Chapter 11; Markings and Placards

Page 1 2
nd
Edition – Rev 0
11-00
MARKINGS AND PLACARDS
11-00 MARKINGS AND PLACARDS
Placards are used to identify the function, operation and operating limitations of systems and
equipment.
The model designation placard is located at the rear of the fuselage on the left side. The
placard identifies the airplane manufacturer, airplane type and serial number, its identification
marks and EASA Type Certificate number.
This Chapter reports the location of these placards and markings as below described:
Exterior colour.
External placards.
Internal placards
Self-adhesive placards are used for all the placards except for the aircraft identification
plate (steel board) and the instruments panel labels.