Tecnam P2002 JF - Internal Placards; Self-Adhesive Placard Installation; Self-Adhesive Placard Removal

Page 200 2
nd
Edition – Rev 0
11-30
INTERNAL PLACARDS – MAINTENANCE PRACTICES
11-30 INTERNAL PLACARDS
MAINTENANCE PRACTICES
In this section are shown the internal placards and their locations on the airplane. Some
placards are self-adhesive, some are stiff riveted placards and some other ones are silk-
screened (no replacement allowable for those installed on the instruments panel).
Self-Adhesive Placard Removal
Tools
Item
Quantity
Part Number / Notes
Solvent
a/r
Commercial type
Procedure
Detach the placard from the airplane using a hot air blower to soften the adhesive, taking care
not to damage any adjacent component or paintwork.
Then clean the surface with the solvent and a lint-free cloth.
Self-Adhesive Placard Installation
Tools
Item
Quantity
Part Number / Notes
Solvent
a/r
Commercial type
Procedure
Clean the surface with a cloth, made moist with the solvent and wipe carefully with a clean
lint-free cloth.
Remove the bottom protective covering from the adhesive side of the placard and position the
placard pressing to the surface.