Tecnam P2002 JF - Wing Installation

Page 204 2
nd
Edition - Rev 0
57-10
WINGS – MAINTENANCE PRACTICE
2. WING INSTALLATION
Pre-installation Procedure
Step
no.
Task description
Additional info &
References
1.
Examine that wing and fuselage attachment
points are free from damages, corrosion or de-
formations
No deformation permitted.
No corrosion permitted.
2.
Examine the main bolt assemblies. Look espe-
cially for corrosion and deformation. Replace
bolts if required
Procedure
Step
no.
Task description
Additional info &
References
1.
Set the Master Switch OFF and ground the
aicraft
2.
Apply jacking procedure
See chapter 7 of this manu-
al.
3.
Install aileron on the wing
4.
Install flap on the wing
5.
Put the wing in position
Refer to Figure 5.
6.
Install wing-fuselage panels
Refer to Figure 5.
7.
Remove seats and cabin floor fairings to access
to the aileron control circuit