Tecnam P2002 JF - MLG Installation

Page 202 2
nd
Edition – Rev 0
32-10
MLG and BRAKES – MAINTENANCE PRACTICES
2. MLG INSTALLATION
Hereinafter they are addressed instruction to install the legs main gear.
Procedure
Step no.
Task description
Additional info &
References
∙
The following instruction are valid for the removal of both leg, we will
treat the left leg
1.
Make sure Master Switches is turned OFF
WARNING
INSURE AIRCRAFT IS SECURE AND STABLE BEFORE BEGINNING ANY WORK.
WORKING UNDER AN IMPROPERLY STABILIZED
AIRCRAFT COULD CAUSE INJURY OR DEATH.
2.
Examine the leg for obvious damage, corrosion
or damage to the surface finish.
3.
Put the leg in position between the beams
Move crosswise the leg in
the bay, then align the
holes
4.
Insert the bolt aligning the holes with respect to
those of the leg
Refer to Figure 5.
5.
Fit the nuts, the washers and the bolts. Tighten
the nut as per standard torque value (*)
Fit the leather spacers.
Errore. L'origine
riferimento non è stata
trovata.
6.
Fit the wheel if removed
See instructions within
this Chapter
7.
Fit brake flexible line on the wheel
Refer to Figure 6.
8.
Bleed the brake system
See instructions within
this Chapter
9.
Fit brake hose binders wrapped around the leg
with anti-abrasion film. Brake hose must be
placed and secured on left side to the leg.
Refer to Figure 7.
10.
Install following cover to the left side.
- LWR CENTRAL WING TO
FUSELAGE FAIRING
- CAP n° 6
Refer to Figure 3.
Refer to Chapter 06-00
Refer to IPC
11.
Fit the fairing wheel if removed
See instructions within
this Chapter