Tecnam P2002 JF - Oil Pressure Sensor Replacement

79-10
OIL SYSTEM – MAINTENANCE AND PRACTICES
2
nd
Edition - Rev 0
Page 208
4. OIL PRESSURE SENSOR REPLACEMENT
The following procedure only applies to the oil pressure sensor: all other indicators of en-
gine group (such as oil temperature, CHT and RPM) are fed by transducers which are part of
the engine: see Rotax Engine Maintenance Manual.
Tools
Item
Quantity
Part Number/Notes
Thread-locker
A/R
Commercial
Procedure
Step
Task description
Additional note
1.
Engage parking brake
2.
Set electric MASTER switch OFF
3.
Disconnect oil pressure indicator connector
You can easily ac-
cess it from the top
engine.
Refer to Figure 13.
4.
Detect the sensor
You can find it be-
hind the oil cooling
radiator
Refer to Figure 14.
5.
Unscrew sensor form the T-joint
Refer to Figure 14.
6.
Remove the sensor, replace if needed
7.
Place into position the new/overhauled unit
Apply thread locker
(e.g. LOCTITE
®
243) to thread
8.
Screw the sensor to the T-joint
9.
Restore electrical connection