Tecnam P2002 JF - Generator Regulator Replacement

Page 205 2
nd
Edition – Rev 0
24-20
POWER DISTRIBUTION – MAINTENACE PRACTICE
3. GENERATOR REGULATOR REPLACEMENT
This procedure applies to generator regulator.
Procedure
Step no.
Generator regulator replacement
Task description
Additional info &
References
1.
Make sure that the Master Switch is set to OFF
2.
Make sure that no external power is provided
3.
Open engine cowling (upper and lower panel)
4.
Remove regulator electrical wires and connector.
Refer to figure below. Record
wires positioning
5.
Unscrew bracket screws and remove the regulator
6.
Put in place new regulator
7.
Fix the bracket screws
8.
Connect the electrical wires and connector.
Make reference to the
recorded wires positioning
9.
Perform functional test: start engine and check
Refer to AFM
10.
Close engine cowling (upper and lower panel)