Tecnam P2002 JF - Strobe Lights Control Unit Replacement

Page 202 2
nd
Edition – Rev 0
33-20
EXTERNAL LIGHTS – MAINTENANCE PRACTICE
3. STROBE LIGHTS CONTROL UNIT REPLACEMENT
Step
no.
Task description
Additional info &
References
1.
Make sure Master Switches are turned off
Ref. Figure 11.
2.
Pull out Strobe light breaker
3.
Open inspection caps
See chap. 06
4.
Remove connectors from control unit and
record correct position for each one
Ref. Figure 11.
5.
Uninstall control unit from fuselage unscrewing
the screws
Ref. Figure 11.
6.
Remove control unit
7.
Replace control unit with new one if needed
8.
Screw CU on fuselage: use screws and groover
washers
Ref. Figure 11.
9.
Connect connectors as recorded during removal
Ref. Figure 11.
10.
Close inspection caps
11.
Perform a functional test
Figure 11. – Control unit