Tecnam P2002 JF - Main Wheel Tyre Removal

Page 218 2
nd
Edition – Rev 0
32-10
MLG and BRAKES – MAINTENANCE PRACTICES
8. MAIN WHEEL TYRE REMOVAL
Procedure
Step
no.
Task description
Additional info &
References
1.
Remove wheel assembly
See instructions within this
Chapter
2.
Remove air from tyre by depressing the valve
stem plunger until air can no longer be heard
escaping from the tyre.
3.
Separate tyre beads from wheel halves, using a
bead breaker or by applying pressure in even
increments around the entire sidewall of the tyre
as close to the tyre beads as possible.
4.
Remove nuts (5), washers (6), and bolts (7)
holding wheel halves and brake disc together.
Refer to Figure 12.
5.
Separate inner wheel half (10), outer wheel half
(8), brake disc (11), and remove hubs from the
tyre. Mark wheel halves to note relationship to
each other for reassembly.
Refer to Figure 12.