Tecnam P2002 JF - ATA 80-10 Troubleshooting

Page 100 2
nd
Edition - Rev 0
80-10
STARTING – DESCRIPTION AND OPERATION
TROUBLESHOOTING
The following troubleshooting steps are provided to augment specific system in-
formation found in this manual about the starting system. For starter system, in
the Rotax Operators Manual, possible problems are listed. At the same time, a
brief description of the necessary remedial action is given.
ATA 80-10 Troubleshooting
Trouble
Likely cause
Action required
Starter does not work
Engine starter fails
Refet to Rotax Operators
Manual
Starter relay fails
Replace relay
Starter relay circuit fails
Check wiring