Tecnam P2002 JF - Ata 27.30 Troubleshooting

Page 100 2
nd
Edition – Rev 0
27-30
FLAPS – TROUBLESHOOTING
TROUBLESHOOTING
The following troubleshooting steps are provided to augment specific system information
found in this manual about the flaps actuation system.
ATA 27.30 TROUBLESHOOTING
Trouble
Likely cause
Action required
Flaps do not operate
Flaps switch failure.
Replace switch
Actuator failure.
Replace actuator
Circuit breaker fails open
Circuit breaker replacement
Flaps indication fails
Position transmitter fails
Check transmitter wiring and
mechanical connection: replace
transmitter if needed
Position indicator fails
Check wiring; replace indicator
if needed (see Chapter 31)