Tecnam P2002 JF - Brake Fluid Draining; Brake Fluid Replacing

Page 201 2
nd
Edition – Rev 0
32-20
BRAKE SYSTEM – MAINTENANCE PRACTICES
1. BRAKE FLUID REPLACING
Procedure (both sides)
Step
no.
Task description
Additional info &
References
1.
Remove reservoir cap
2.
Unscrew line nipple from disk caliper
3.
Using a manually operated dump, add brake
fluid FLUID41 (nato code: H515) until level
reaches bottom of reservoir, reattach line to
caliper avoiding fluid spill.
4.
Top-off brake fluid to ¾ of maximum level
5.
Screw line nipple to disk caliper
6.
Put reservoir cap
2. BRAKE FLUID DRAINING
Procedure (both sides)
Step
no.
Task description
Additional info &
References
1.
Pull brake lever to pressurize circuit
2.
Loosen small escape valve allowing fluid spurt
3.
Close small valve and release brake lever
4.
Repeat operations 1., 2. And 3. Until fluid
comes out clean and no longer in spurts,
proving absence of air bubbles
5.
Top-off reservoir with needed amount of brake
fluid
6.
Close reservoir and repeat operation for other
brake