Tecnam P2002 JF - Lubrication Charts and Schedule

2
nd
Edition - Rev 0
Page 3
05-30
LUBRICATION
2. Lubrication charts and schedule
The lubrication charts consist of individual illustrations for the various aircraft systems;
for each component to be lubricated, identified by a number, it is reported the frequency
of application. The same number is reported on the applicable component illustra-
tion/schematic which shows in detail the lubrication points.
For each item reference is made to the illustrations and, if applicable, inspection cap to
remove.
General rules
External hinges, bearings and bushings – for those items exposed to the external envi-
ronment, clean exterior surfaces before lubricating, lubricate, then apply a protective
coat of grease.
Lubrication points – wipe all lubrication points clean of old grease, oil, dirt, etc. before
lubricating.
Aerosol Grease – approved aerosol grease applying is allowed for all lubrication points,
unless otherwise indicated.
WARNING
Item no.
Lubrication points
Frequency
1
Rudder upper bushing
100 Hrs
2
Rudder lower bushing
100 Hrs
3
Teflon road-stop LH
100 Hrs
4
Teflon road-stop RH
100 Hrs
5
Stabilator rod end
100 Hrs
6
Stabilator support bushing LH
100 Hrs
7
Stabilator support bushing RH
100 Hrs
8
9
Hinges
100 Hrs
10
Flaps lower bushing
100 Hrs
11
Stabilator loop
100 Hrs
- Do not lubricate cockpit controls.
- Do not apply lubricant to rubber parts.
- Do not lubricate control cables, this causes slippage.
Refer to Rotax Engine Maintenance Manual P/N 899372 for lub-
ricants approved to be used for engine parts.