Tecnam P2002 JF - Page 501

Page 204 2
nd
Edition – Rev 0
31-10
INDICATING SYSTEM –MAINTENACE PRACTICES
Procedure
Step
no.
Clamped Indicators Replacement
Task description
Additional info &
References
1.
Engage parking brake
2.
Set electric MASTER switch OFF
3.
Pull out related breaker
Ref.: Chapter 24
4.
Remove the instruments panel upper cover
5.
Remove all instrument hoses and connections
6.
Unscrew the attaching nuts which fix the
instrument to the stirrup(s)
Hold firmly the instrument by
hand during removal
7.
Clear the instrument of the instrument panel
8.
Place into position the new/overhauled unit in
correspondence of the instrument panel cut-out
9.
Install the attaching nuts which fix the instrument
to the stirrup(s)
Hold firmly the instrument by
hand during installation. Do
not over tighten nuts to avoid
instrument case or stirrups
damage
10.
Install all instrument hoses and connections
removed at Errore. L'origine riferimento non è stata trovata..
11.
Install the instruments panel upper cover