Tecnam P2002 JF - Page 551

Page 102 2
nd
Edition – Rev 0
32-20
BRAKE SYSTEM – TROUBLESHOOTING
ATA 32-20 Troubleshooting
Trouble
Likely cause
Action required
Discs worn below
minimum wear limits.
Replace linin
Insufficient hydraulic
pressure.
Make reference to “Unable
to obtain sufficient
hydraulic brake pressure”
troubleshooting section
Organic brake lining
carburized (overheated).
Replace lining.
Pressure plate contacting
torque plate assembly.
Check for correct torque
plate/wheel installation.
New Lining installed with
old disc, Lining not seated
in wear track creating
partial contact with disc.
Replace excessively worn
disc.
Parking brake won’t hold.
Valve failure
Replace valve
Control cable failure
Replace control cable