Henkel SISTA SL509 acetic silicon for high
temperatures
Surface preparation
Surfaces must be clean, dry and free from all
traces of grease, oil and dust.
Application (cartridge)
Cut off the tip of the nozzle to suit joint width
and apply the sealant into the joint with a
suitable hand operated gun.
Do not apply at temperatures below 40°F
(5°C) or above 105°F (40°C).
Overpainting Not allowed
Tesa Professional – Spray Glue Permanent
p/n 60021 or 60020
Application
Shake can well before use and remove any
dried-on glue from the nozze For new
applications, test suitability by gluing a
sample
The parts to be bonded must be dry and free
from dust and grease. Cleaning with tesa®
INDUS TRY CLEANER 60040
recommended.
After use, turn can upside-down and expel
glue from nozzle until only propellant comes
out
Overspray from Spray Glues can easily be
removed with Tesa 60042 ADHESIVE
REMOVER
To Next Page
Loading...
