Tecnam P2002 JF - Page 916

Page 202
SUPPLEMENT S4
SERVICING- POST-SHIPMENT ASSEMBLY INSTRUCTION
2
nd
Edition - Rev 0
3. BATTERY CABLES CONNECTION
This paragraph provides instruction for battery installation.
Procedure
Step
no.
Battery cables installation
Task description
Additional info &
References
1.
Engage parking brake
2.
Make sure that Master switch is set to OFF
3.
Open inspection cap F9
Refer basic manual, ATA 06
WARNING
When installing a battery, take special care to ensure that no
sparks are created by tools, and that the terminals are not
shorted out by tools .
4.
Remove the protective tape
5.
Connect the negative cable if not installed
6.
Connect the positive cable to the battery
Refer to Figure 12.3.
7.
Make sure that foreign objects and tools
have been removed
8.
Close inspection cap F9
Refer basic manual, ATA 06