TEEJET 5000 OPERATORS MANUAL FERTILISER DISTRIBUTOR, BREDAL HYDR. B
4.59
WARNING ENCODE
The following warnings can be set in this menu:
It is recommended to turn all warnings, which are not wanted “OFF”.
PTO: Warning ON/OFF and MAX/MIN-limits for revolutions.
KM/H: Warning ON/OFF and MAX/MIN-limits for speed.
SLIP: Warning ON/OFF and MAX/MIN-limits for wheel slip in %.
RPM 1: Warning ON/OFF and MAX/MIN-limits for revolutions. Encode as
RPM.
KG
LEFT: Warning ON/OFF and amount of kg (min.) at which warning is
wanted.
NB: The encoded limits must exceed the limits encoded. If a warning is
required when an axle stops (0 RPM) then set the minimum limit to 1
DATE - CLOCK:
Set the date and time in this menu:
HOURS - MINUTES - YEAR - MONTH - DAY.
FLOW FACTOR
Please refer to the documentation supplied with the spreader for information
regarding the FLOW FACTOR. If the flow factor must be altered, press and hold
the “HOLD” key for approx. 5 seconds before accepting the spreader type.
½ GEAR
If the spreader is fitted with a ½ gear then this must be encoded. Press and hols
the “HOLD” key for approx. 5 seconds before accepting the spreader type. “½
GEAR” can now be switched between ON (if the spreader is fitted with a ½ gear)
and OFF (if the spreader is not fitted with ½ gear).
To Next Page
Loading...