SLURRY SPREADER, ZUNHAMMER TEEJET 5000 OPERATORS MANUAL
7.54
WARNING ENCODE
The following warnings can be set in this menu:
It is recommended to turn all warnings, which are not wanted “OFF”.
PTO: Warning ON/OFF and MAX/MIN-limits for revolutions.
KM/H: Warning ON/OFF and MAX/MIN-limits for speed.
SLIP: Warning ON/OFF and MAX/MIN-limits for wheel slip in %.
RPM: Warning ON/OFF and MAX/MIN-limits for revolutions.
RPM 1: Warning ON/OFF and MAX/MIN-limits for shaft speed. Encode in
RPM.
PLC: Warning ON/OFF for PLC warnings.
There are 4 PLC warnings given for the following:
No slurry flow
High pressure
Tank valve closed
Fill pipe in
NB: The encoded limits must exceed the limits encoded. If a warning is
required when an axle stops (0 RPM) then set the minimum limit to 1.
Besides these warnings an automatic rate warning is given if the application rate
varies from the encoded by 20%.
DATE - CLOCK:
Set the date and time in this menu:
HOURS - MINUTES - YEAR - MONTH - DAY.
To Next Page
Loading...