FERTILISER DISTRIBUTOR, BREDAL K RAMP TEEJET 5000 OPERATORS MANUAL
4.82
LIME SPREADER ENCODE
This menu allows the operator to encode the various settings that are necessary
for spreading. Each implement has it’s own set of encodements. Encodements
such as speed sensor (and its calibration) have their own values under each
implement.
Always check these encodements in the status screen each time you change
implements.
DOSE RATE:
The effective working width of the spreader must be
encoded under “DISTRIB: WIDTH” before DOSE
RATE is selected.
Some spreaders are fitted with a ½ gear. It is possible
to alter the calculated gear by pressing the “GEAR+”
key. A new calculation must take place if the calculated
gear has been altered. If the calculated scale is greater
than 300, then GEAR+ must be altered again.
Please refer to the documentation supplied with the
spreader for more information.
To Next Page
Loading...