TEEJET 5000 OPERATORS MANUAL FERTILISER DISTRIBUTOR, OTHER TYPE WITH REG.
4.21
SYSTEM B PLUG
There are 2 system plugs on the back of the TeeJet 5000.
The System A plug is compatible with older TeeJet 5000 versions.
The System B plug is for new connections.
ACTIVE 0 VOLT: The individual sections are opened with 0V.
ACTIVE 12 VOLT: The individual sections are opened with 12V.
ON/OFF: ON: The system B plug is used.
OFF: The system B plug is not used.
WARNING ENCODE
The following warnings can be set in this menu:
It is recommended to turn all warnings, which are not wanted “OFF”.
PTO: Warning ON/OFF and MAX/MIN-limits for revolutions.
KM/H: Warning ON/OFF and MAX/MIN-limits for speed.
SLIP: Warning ON/OFF and MAX/MIN-limits for wheel slip in %.
MIS-
DOSERATE: Warning ON/OFF and MAX difference in +/-%
KG
LEFT: Warning ON/OFF and amount of Kg (min.) at which warning is
wanted.
RPM 1: Warning ON/OFF and MAX/MIN-limits for shaft speed. Encode in
RPM.
NB: The encoded limits must exceed the limits encoded. If a warning is
required when an axle stops (0 RPM) then set the minimum limit to 1.
DATE – CLOCK
Set the date and time in this menu:
HOURS – MINUTES – YEAR – MONTH – DAY.
To Next Page
Loading...