TEEJET 5000 OPERATORS MANUAL FERTILISER DISTRIBUTOR, RAUCH AERO
4.91
FERTILISER DISTRIBUTOR OPERATION
FORWARD SPEED:
The primary function under fertiliser distributor is
forward speed.
Forward speed is displayed in KPH with 1 decimal.
Forward speed is calculated from the signal from the
speed sensor selected in encode (wheel tractor, wheel
sprayer or radar).
SPREADER SECTION INDICATION:
The picture to the left shows a 4-section spreader with
both sections open. The number of sections can be
changed in “ENCODE”.
The figure to the right indicates which calibration is
being used.
RPM FOR FEED ROLLERS AND REGULATION:
The speed of the feed rollers is displayed; this speed
expresses the application rate. An arrow to the left of
the screen shows whether the feed roller speed is
increasing or decreasing.
I
When the area override sensor is activated (not
counting area) “I” is displayed and all sections will
disappear.
FERTILISER SPREADER FUNCTIONS
There are 2 different function sets in this menu. The
displayed set depends on whether automatic or
manual application control has been selected.
The following describes each function set individually.
To Next Page
Loading...