SEED DRILL, LEMKEN TEEJET 5000 OPERATORS MANUAL
5.58
NORMAL START
As the motors used for altering the seed rate must be started at a certain level
before being able to adjust the seed rate up or down it is necessary to decide at
what speed the motors should start.
This is encoded as a forward speed. The motor will start with the RPM required to
sow at the given forward speed.
To encode the forward speed at which the motor should start at do as follows:
1
When this is shown in the display (see page 5.
xx) press and hold the "HOLD" key for 5
seconds.
2 Select "START KM/H" and encode the forward speed that the motor should
start at.
Min. = 1.5 kph
Max. = 3.0 kph
To Next Page
Loading...