TEEJET 5000 OPERATORS MANUAL FERTILISER DISTRIBUTOR, RAUCH AXERA H
4.119
+: Each key press increases the application rate. If the key remains
pressed then the application rate is increased by a suitable
amount. The actual application rate can be seen on the display.
-: Each key press decreases the application rate. If the key remains
pressed then the application rate is decreased by a suitable
amount. The actual application rate can be seen on the display.
POS.: Pressing this key displays the gate position, changes between the
left- and right-hand side.
FERTILISER DISTRIBUTOR ENCODE
This menu allows the operator to encode the various settings that are necessary
for spreading. Each implement has it’s own set of encodements. Encodements
such as speed sensor (and its calibration) have their own values under each
implement.
Always check these encodements in the status screen each time you change
implements.
WORKING WIDTH:
The working width for the spreader used. Each spreader section is encoded
individually in centimetres (section 1 is on the left-hand side of the machine)
NB: All unused sections must be encoded as 0.
The total working width can be seen at the bottom of the display under encode.
To Next Page
Loading...