TEEJET 5000 OPERATORS MANUAL SLURRY SPREADER, ZUNHAMMER
7.51
REVS. SENSOR
Encode the number of pulses per revolution given for the
individual sensors.
FILL MENU
Before the slurry spreader is used a PWM calibration of the proportional
valve MUST be carried out. This PWM calibration is normally carried out by
the engineer when fitting the system to the slurry spreader. The procedure
for this calibration is described in the PWM section under ENCODE.
It is possible to use a fixed displacement pump for filling the slurry spreader. When
the fill signal and the implement signals are active the pump will run at a pre-
encoded speed.
1. Set the spreader to fill.
2. Press the ”+” and ”-” keys to adjust the required
pump speed.
3. The pump speed will change and the actual RPM is
displayed.
4. When the required pump speed has been reached
press the ”RETURN” key.
To Next Page
Loading...