TeeJet 5000 - Distributor Width; Forward Speed Sensor; Implement Sensor; Metre Switch

FERTILISER DISTRIBUTOR, OTHER TYPE TEEJET 5000 OPERATORS MANUAL
4.10
DISTRIBUTOR WIDTH
The working width for the spreader. If the spreader is fitted with individual sections,
then encode each section by itself (starting from the left). Otherwise encode the
width as 1 section (all other sections as 0).
FORWARD SPEED SENSOR
The TeeJet 5000 V.4 fertiliser distributor program (Other type) gives the option of
choosing between 3 different speed sensors (Wheel tractor, Wheel spreader,
Radar).
WHEEL TRACTOR
The speed signal can come from a sensor fitted in the gear box, or on a drive
shaft, or from a sensor fitted on a wheel, depending on the make and model of the
tractor used for fertiliser spreading.
WHEEL SPREADER
If the spreader is fitted with a speed sensor, press the “WHEEL SPREADER” key.
The TeeJet 5000 will now receive speed signals from the sensor fitted to the
spreader, and gives, as a rule, a very accurate speed-reading.
RADAR
Working in crops that are blowing in the wind or working in areas with surface
water can affect the accuracy of the radar, we recommend using a speed sensor
fitted to the tractor or spreader under these circumstances.
Please refer to chapter 2 for speed sensor calibration
IMPLEMENT SENSOR
Using 1 of the following 3 options, select how the area counter is to be switched on
and off:
1. LIFT
2. FERTILISER DISTRIBUTOR
3. PTO
The selected sensor is shown at the top of the display.
METRE SWITCH
Select whether the metre counter is started/stopped manually “MANUAL” or by
the selected implement sensor “IMPLEM. SENSOR”.