FERTILISER DISTRIBUTOR, BREDAL TEEJET 5000 OPERATORS MANUAL
4.40
CLOSING THE GATE
This key is used to close the gate on the Bredal
spreader, i.e. driving on the road.
This function must only be used when the belt has
stopped (override sensor is active). The gate will open
automatically when spreading starts again.
SECTION ON/OFF:
This picture is displayed during spreading.
I
When the area override sensor is activated (not
counting area) “I” is displayed and all sections will
disappear.
FERTILISER DISTRIBUTOR ENCODE
This menu allows the operator to encode the various settings that are necessary
for spreading. Each implement has it’s own set of encodements. Encodements
such as speed sensor (and its calibration) have their own values under each
implement.
Always check these encodements in the status screen each time you change
implements.
To Next Page
Loading...