TEEJET 5000 OPERATORS MANUAL FERTILISER DISTRIBUTOR, BREDAL K RAMP
4.83
The required application rate and spreader setup is encoded thus:
Encode the required application rate with the numerical
keypad under “DOSE TON/HA”.
The “SPECIFIC GRAVITY” is found using the specific
gravity tester supplied by BREDAL
Pressing “CALC. CALIB.” Calculates the correct
SCALE and GEAR.
This menu cannot be left until “CALC. CALIB.” has been pressed.
The required DOSE RATE along with the specific gravity and the distributor
width gives:
The scale setting
The correct gear on the spreader
NOTE: The settings must be re-calculated under “DOSE RATE” each
time the working width of the spreader has been altered.
TON/LEFT:
The amount filled into the spreader must be encoded here; to be able to see how
much lime is left in the hopper.
NOTE: If there is some lime left in the hopper before refilling, then this amount
must be added to the amount filled thus:
Amount left in hopper + filled amount = Ton left.
HA LEFT
Encode the size of the field to be spread here. END TIME, is calculated from this
encodement.
To Next Page
Loading...