TEEJET 5000 OPERATORS MANUAL FERTILISER DISTRIBUTOR, BREDAL K RAMP
4.87
WORK HOUR ON/OFF
Select whether the timer function is started/stopped manually via the function key
in the operation menu or by the selected implement sensor.
REVS. SENSOR
Encode the number of pulses per revolution the PTO sensor sends per revolution.
If the TeeJet PTO sensor kit is used (932-983) encode 1.
WARNING ENCODE
The following warnings can be set in this menu:
It is recommended to turn all warnings, which are not wanted “OFF”.
PTO: Warning ON/OFF and MAX/MIN-limits for revolutions.
KM/H: Warning ON/OFF and MAX/MIN-limits for speed.
SLIP: Warning ON/OFF and MAX/MIN-limits for wheel slip in %.
TON
LEFT: Warning ON/OFF and amount of kg (min.) at which warning is
wanted.
NB: The encoded limits must exceed the limits encoded. If a warning is
required when an axle stops (0 RPM) then set the minimum limit to 1
DATE - CLOCK:
Set the date and time in this menu:
HOURS - MINUTES - YEAR - MONTH - DAY.
OFFSET
1. Press and hold this key for approx. 5 seconds
before the selected spreader is accepted.
2. Encode the required offset value using the
numeric keypad.
To Next Page
Loading...