TEEJET 5000 OPERATORS MANUAL FERTILISER DISTRIBUTOR, REI
β
l
4.129
FERTILISER DISTRIBUTOR ENCODE
This menu allows the operator to encode the various settings that are necessary
for spreading. Each implement has it’s own set of encodements. Encodements
such as speed sensor (and its calibration) have their own values under each
implement.
Always check these encodements in the status screen each time you change
implements.
DOSE RATE
The required application rate is encoded in TON/HA.
LOGGING
The date and flow (tons/min.) are registered every other minute. Registration of
data will only take place if; the spreader is operating (area override sensor not
activated), and the consumption is minimum 0.1 ton per minute.
Pressing the “LOG DATA” key displays the data that has been registered (this
key is only displayed if there is registered data).
NOTE! These registrations can NOT be deleted, and data is logged from
position 1 again when the memory is full.
The maximum allowed flow (ton/min.) is encoded by pressing the “ENCODE
DOS.” Key, and thereafter by using the numerical keys.
If the maximum encoded flow is exceeded an alarm will sound. Pressing the “OK”
key cancels the warning. The warning will only be given again if the flow (ton/min)
drops under and thereafter exceeds the encoded max. flow.
To Next Page
Loading...