TEEJET 5000 OPERATORS MANUAL OTHER IMPLEMENT
8.5
FORWARD SPEED SENSOR
The TeeJet 5000 V.4 other implement program gives the option of choosing
between 3 different speed sensors (Wheel tractor, Wheel spreader, Radar).
WHEEL TRACTOR
The speed signal can come from a sensor fitted in the gear box, or on a drive
shaft, or from a sensor fitted on a wheel, depending on the make and model of the
tractor used.
RADAR
If the tractor is fitted with radar then select “RADAR” and forward speed will be
measured from the radar. Radar and the number of pulses per metre will be
displayed at the top of the screen.
IMPORTANT! Working in crops that are blowing in the wind or working in areas
with surface water can affect the accuracy of the radar, we
recommend using a speed sensor fitted to the tractor under these
circumstances.
WHEEL IMPLEMENT
If the implement is fitted with a speed sensor, then press the “WHEEL
IMPLEMENT” key. The TeeJet 5000 will now use this sensor for forward speed
measurement.
IMPLEMENT SENSOR
The implement override sensor starts and stops area measurement.
The following options can be selected in “OTHER IMPLEMENT”:
1. Lift
2. Implement
3. PTO (if a sensor is fitted)
METRE SWITCH
Select whether the metre counter is started/stopped manually “MANUAL” or by
the selected implement sensor “IMPLEM. SENSOR”.
WORK HOUR ON/OFF
Select whether the timer function is started/stopped manually via the function key
in the operation menu or by the selected implement sensor.
To Next Page
Loading...