TEEJET 5000 OPERATORS MANUAL FERTILISER DISTRIBUTOR, OTHER TYPE WITH REG.
4.17
FERTILISER DISTRIBUTOR ENCODE
This menu allows the operator to encode the various settings that are necessary
for spreading. Each implement has it’s own set of encodements. Encodements
such as speed sensor (and its calibration) have their own values under each
implement.
Always check these encodements in the status screen each time you change
implements.
DOSE RATE
The required application rate is encoded in KG/HA.
KG LEFT
The amount filled into the hopper must be encoded here; to be able to see how
much fertiliser is left in the hopper.
NOTE! If there is some fertiliser left in the hopper before refilling, then this
amount must be added to the amount filled thus:
Amount left in hopper + filled amount = Kg. Left.
HA LEFT
Encode the size of the field to be spread here. END TIME is calculated from this
encodement.
To Next Page
Loading...