TeeJet 5000 - Hold Key; Selectable Seed Drill Functions

SEED DRILL, LEMKEN TEEJET 5000 OPERATORS MANUAL
5.34
HOLD KEY
Press if the present bout is not required in the selected
rhythm. This function “holds” the present status
regardless of how many times the drill is raised. When
this function is activated, “HOLD” flashes on the
display.
SELECTABLE SEED DRILL FUNCTIONS
KM/H: Forward speed in kilometres per hour.
KG: The amount sown in KG.
KG LEFT: The amount in KG of seed left in the
hopper.
KM/H: Forward speed in kilometres per hour with 1 decimal. Forward
speed is measured from the sensor selected under “ENCODE”.
KG: The amount sown in KG, measured by a sensor fitted on the drill
shaft. Calibrating the system is necessary to ensure correct
operation and this is done under “ENCODE”.
KG LEFT: The amount in KG of seed left in the hopper (the amount filled in
must be encoded before work commences).
Pressing the “NEXT PAGE” key displays the next available functions:
+XX%: Step, increase.
-XX%: Step, decrease.
NORMAL: Returns to normal seed rate.
+XX%: Step, increase of the desired seed rate in steps. The size of the
steps are encoded in “ENCODE”
-XX%: Step, decrease of the desired seed rate in steps. The size of the
steps are encoded in “ENCODE”
NORMAL: Normal seed rate. Regardless of how many steps the application
rate has been increased/decreased by, pressing this key will
return the application rate to normal.
Pressing the “NEXT PAGE” key displays the next available functions: