SEED DRILL, LEMKEN TEEJET 5000 OPERATORS MANUAL
5.52
SEED DRILL ENCODEMENT
This menu allows the operator to encode the various settings that are necessary
for sowing. Each implement has it’s own set of encodements. Encodements such
as speed sensor (and its calibration) have their own values under each implement.
Always check these encodements in the status screen each time you change
implements.
DOSE RATE
The required seed rate in kilo per hectare with 1
decimal is encoded here.
Before the system can be calibrated, it is necessary
to encode the total working width of the seed drill.
If the encoded sow width is 0, the program will
automatically change to sow width encodement,
(remember that the effective sow width is encoded in
centimetres), pressing return changes the screen back
to the calibration screen.
LOAD FIGURE:
Pressing this key changes to a different screen where it
is possible to encode “GRAMS/PULSE” should this be
deleted by mistake.
To Next Page
Loading...