FERTILISER DISTRIBUTOR, RAUCH BETA/DELTA TEEJET 5000 OPERATORS MANUAL
4.104
1. AUTOMATIC APPLICATION CONTROL.
KG/HA1
KG/HA2 These 3 application rates are set in
“ENCODE” and can be selected under
“OPERATION”.
KG/HA3
Pressing one of these keys displays the encoded required application rate. Not
the actual application rate.
Before accurate automatic application control can take place, it is important to
calibrate the system using the fertiliser to be spread.
To minimize the risk of incorrect operation/application, the following automatic
warnings may be displayed.
DOSERATE
If the required application rate can not be achieved.
Pressing the “NEXT PAGE” key displays the next functions.
HA: Area.
KG: Consumption in KG.
KG REST: How many KG are left in the spreader at
present.
HA: Area counter. Worked area since the last reset.
NOTE: Total area counter is found in “DATA/DELETE”.
KG: Total KG used, calculated from forward speed and gate position.
This function presupposes correct calibration.
NOTE: Total KG counter is found in “DATA/DELETE”.
KG REST: Total KG remaining in the hopper (the amount must be encoded
before start).
Pressing the “NEXT PAGE” key displays the next functions.
To Next Page
Loading...